Texas Instruments AFE79 Series - 2.16.296 Register 46 Fh (offset = 46 Fh) [reset = 0 h]; 2.16.297 Register 470 h (offset = 470 h) [reset = 1 h]; 2.16.298 Register 473 h (offset = 473 h) [reset = 0 h]

www.ti.com IO Wrap Register Map
1089
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
2.16.296 Register 46Fh (offset = 46Fh) [reset = 0h]
Figure 2-2559. Register 46Fh
7 6 5 4 3 2 1 0
ACTIV_BIR_DIR_CTRL_GPIO_27 reserved
R/W-0h R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2575. Register 46F Field Descriptions
Bit Field Type Reset Description
3-1
ACTIV_BIR_DIR_C
TRL_GPIO_27
R/W 0h
Control to indicate whether the GPIO_27 needs dynamic
ouptu t enabling.
0 to 3 --> Static direction
4 --> Use the IO for 3 pin SPI B2 SDIO.
5 --> Use the IO for 4 pin SPI B2 SDO
6 --> Use the IO for 3 pin SPI B1 SDIO.
7 --> use the IO for 4 pin SPI B1 SDO.
0-0 reserved R/W 0h
2.16.297 Register 470h (offset = 470h) [reset = 1h]
Figure 2-2560. Register 470h
7 6 5 4 3 2 1 0
reserved reserved BUF_DIR_CTRL_GPIO_28
R/W-0h R/W-0h R/W-1h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2576. Register 470 Field Descriptions
Bit Field Type Reset Description
7-5 reserved R/W 0h
4-2 reserved R/W 0h
1-0
BUF_DIR_CTRL_G
PIO_28
R/W 1h
Controls the direction of GPIO
0 both input and output are not selected.. can be used for
analog
1 input mode
2 output mode
3 shouldnt be used
2.16.298 Register 473h (offset = 473h) [reset = 0h]
Figure 2-2561. Register 473h
7 6 5 4 3 2 1 0
ACTIV_BIR_DIR_CTRL_GPIO_28 reserved
R/W-0h R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset