Texas Instruments AFE79 Series - 2.16.153 Register 2 CAh (offset = 2 CAh) [reset = 0 h]; 2.16.154 Register 2 CCh (offset = 2 CCh) [reset = 1 h]; 2.16.155 Register 2 CDh (offset = 2 CDh) [reset = 2 h]; 2.16.156 Register 2 CEh (offset = 2 CEh) [reset = 0 h]

IO Wrap Register Map www.ti.com
1042
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
2.16.153 Register 2CAh (offset = 2CAh) [reset = 0h]
Figure 2-2416. Register 2CAh
7 6 5 4 3 2 1 0
ODRIV_DS_GPIO_50
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2432. Register 2CA Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
50
R/W 0h output buffer drive strength.
2.16.154 Register 2CCh (offset = 2CCh) [reset = 1h]
Figure 2-2417. Register 2CCh
7 6 5 4 3 2 1 0
PULL_CTRL_GPIO_51
R/W-1h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2433. Register 2CC Field Descriptions
Bit Field Type Reset Description
2-0
PULL_CTRL_GPIO
_51
R/W 1h
Bit 0 indicates Pull up enable.
Bit <1> Indicates Pull value.
Bit <2> is unused.
2.16.155 Register 2CDh (offset = 2CDh) [reset = 2h]
Figure 2-2418. Register 2CDh
7 6 5 4 3 2 1 0
IBUF_ST_GPIO_51
R/W-2h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2434. Register 2CD Field Descriptions
Bit Field Type Reset Description
1-0
IBUF_ST_GPIO_5
1
R/W 2h Input buffer signal strength
2.16.156 Register 2CEh (offset = 2CEh) [reset = 0h]
Figure 2-2419. Register 2CEh
7 6 5 4 3 2 1 0
ODRIV_DS_GPIO_51
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset