Texas Instruments AFE79 Series - 2.8.87 Register F6 h (offset = F6 h) [reset = 0 h]; 2.8.88 Register F7 h (offset = F7 h) [reset = 0 h]; 2.8.89 Register F8 h (offset = F8 h) [reset = 0 h]; 2.8.90 Register F9 h (offset = F9 h) [reset = 0 h]

Macro Register Map www.ti.com
566
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
2.8.87 Register F6h (offset = F6h) [reset = 0h]
Figure 2-1018. Register F6h
7 6 5 4 3 2 1 0
MACRO_ERROR_EXTENDED_CODE_2[23:16]
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1026. Register F6 Field Descriptions
Bit Field Type Reset Description
7-0
MACRO_ERROR_
EXTENDED_COD
E_2[23:16]
R 0h
Field contains information about the nature of error (in case of
ERROR_IN_OPERAND or ERROR_IN_EXECUTION).
Interpretation of this depends on the specific
MACRO_OPCODE that caused the error.
2.8.88 Register F7h (offset = F7h) [reset = 0h]
Figure 2-1019. Register F7h
7 6 5 4 3 2 1 0
MACRO_ERROR_EXTENDED_CODE_2[31:24]
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1027. Register F7 Field Descriptions
Bit Field Type Reset Description
7-0
MACRO_ERROR_
EXTENDED_COD
E_2[31:24]
R 0h
Field contains information about the nature of error (in case of
ERROR_IN_OPERAND or ERROR_IN_EXECUTION).
Interpretation of this depends on the specific
MACRO_OPCODE that caused the error.
2.8.89 Register F8h (offset = F8h) [reset = 0h]
Figure 2-1020. Register F8h
7 6 5 4 3 2 1 0
MACRO_RESULT_REG0[7:0]
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1028. Register F8 Field Descriptions
Bit Field Type Reset Description
7-0
MACRO_RESULT_
REG0[7:0]
R 0h
Macro result register # 0. Interpretation of the contents of this
register depend on the last macro command
2.8.90 Register F9h (offset = F9h) [reset = 0h]
Figure 2-1021. Register F9h
7 6 5 4 3 2 1 0
MACRO_RESULT_REG0[15:8]
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset