Texas Instruments AFE79 Series - 2.8.43 Register CAh (offset = CAh) [reset = 0 h]; 2.8.44 Register CBh (offset = CBh) [reset = 0 h]; 2.8.45 Register CCh (offset = CCh) [reset = 0 h]; 2.8.46 Register CDh (offset = CDh) [reset = 0 h]

www.ti.com Macro Register Map
553
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
2.8.43 Register CAh (offset = CAh) [reset = 0h]
Figure 2-974. Register CAh
7 6 5 4 3 2 1 0
MACRO_OPERAND_REG10[23:16]
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-982. Register CA Field Descriptions
Bit Field Type Reset Description
7-0
MACRO_OPERAN
D_REG10[23:16]
R/W 0h
Macro operand register # 10. Interpretation of the operand(s)
in this register are dependent on MACRO_OPCODE
2.8.44 Register CBh (offset = CBh) [reset = 0h]
Figure 2-975. Register CBh
7 6 5 4 3 2 1 0
MACRO_OPERAND_REG10[31:24]
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-983. Register CB Field Descriptions
Bit Field Type Reset Description
7-0
MACRO_OPERAN
D_REG10[31:24]
R/W 0h
Macro operand register # 10. Interpretation of the operand(s)
in this register are dependent on MACRO_OPCODE
2.8.45 Register CCh (offset = CCh) [reset = 0h]
Figure 2-976. Register CCh
7 6 5 4 3 2 1 0
MACRO_OPERAND_REG11[7:0]
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-984. Register CC Field Descriptions
Bit Field Type Reset Description
7-0
MACRO_OPERAN
D_REG11[7:0]
R/W 0h
Macro operand register # 11. Interpretation of the operand(s)
in this register are dependent on MACRO_OPCODE
2.8.46 Register CDh (offset = CDh) [reset = 0h]
Figure 2-977. Register CDh
7 6 5 4 3 2 1 0
MACRO_OPERAND_REG11[15:8]
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset