Texas Instruments AFE79 Series - 2.16.150 Register 2 C6 h (offset = 2 C6 h) [reset = 0 h]; 2.16.151 Register 2 C8 h (offset = 2 C8 h) [reset = 1 h]; 2.16.152 Register 2 C9 h (offset = 2 C9 h) [reset = 2 h]

www.ti.com IO Wrap Register Map
1041
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
Table 2-2428. Register 2C5 Field Descriptions
Bit Field Type Reset Description
1-0
IBUF_ST_GPIO_4
9
R/W 2h Input buffer signal strength
2.16.150 Register 2C6h (offset = 2C6h) [reset = 0h]
Figure 2-2413. Register 2C6h
7 6 5 4 3 2 1 0
ODRIV_DS_GPIO_49
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2429. Register 2C6 Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
49
R/W 0h output buffer drive strength.
2.16.151 Register 2C8h (offset = 2C8h) [reset = 1h]
Figure 2-2414. Register 2C8h
7 6 5 4 3 2 1 0
PULL_CTRL_GPIO_50
R/W-1h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2430. Register 2C8 Field Descriptions
Bit Field Type Reset Description
2-0
PULL_CTRL_GPIO
_50
R/W 1h
Bit 0 indicates Pull up enable.
Bit <1> Indicates Pull value.
Bit <2> is unused.
2.16.152 Register 2C9h (offset = 2C9h) [reset = 2h]
Figure 2-2415. Register 2C9h
7 6 5 4 3 2 1 0
IBUF_ST_GPIO_50
R/W-2h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2431. Register 2C9 Field Descriptions
Bit Field Type Reset Description
1-0
IBUF_ST_GPIO_5
0
R/W 2h Input buffer signal strength