Texas Instruments AFE79 Series - 2.16.69 Register 25 Ah (offset = 25 Ah) [reset = 0 h]; 2.16.70 Register 25 Ch (offset = 25 Ch) [reset = 1 h]; 2.16.71 Register 25 Dh (offset = 25 Dh) [reset = 2 h]; 2.16.72 Register 25 Eh (offset = 25 Eh) [reset = 0 h]

IO Wrap Register Map www.ti.com
1018
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
2.16.69 Register 25Ah (offset = 25Ah) [reset = 0h]
Figure 2-2332. Register 25Ah
7 6 5 4 3 2 1 0
ODRIV_DS_GPIO_22
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2348. Register 25A Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
22
R/W 0h output buffer drive strength.
2.16.70 Register 25Ch (offset = 25Ch) [reset = 1h]
Figure 2-2333. Register 25Ch
7 6 5 4 3 2 1 0
PULL_CTRL_GPIO_23
R/W-1h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2349. Register 25C Field Descriptions
Bit Field Type Reset Description
2-0
PULL_CTRL_GPIO
_23
R/W 1h
Bit 0 indicates Pull up enable.
Bit <1> Indicates Pull value.
Bit <2> is unused.
2.16.71 Register 25Dh (offset = 25Dh) [reset = 2h]
Figure 2-2334. Register 25Dh
7 6 5 4 3 2 1 0
IBUF_ST_GPIO_23
R/W-2h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2350. Register 25D Field Descriptions
Bit Field Type Reset Description
1-0
IBUF_ST_GPIO_2
3
R/W 2h Input buffer signal strength
2.16.72 Register 25Eh (offset = 25Eh) [reset = 0h]
Figure 2-2335. Register 25Eh
7 6 5 4 3 2 1 0
ODRIV_DS_GPIO_23
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset