Texas Instruments AFE79 Series - 2.16.199 Register 308 h (offset = 308 h) [reset = 1 h]; 2.16.200 Register 309 h (offset = 309 h) [reset = 2 h]; 2.16.201 Register 30 Ah (offset = 30 Ah) [reset = 0 h]

www.ti.com IO Wrap Register Map
1055
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
Table 2-2477. Register 306 Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
65
R/W 0h output buffer drive strength.
2.16.199 Register 308h (offset = 308h) [reset = 1h]
Figure 2-2462. Register 308h
7 6 5 4 3 2 1 0
PULL_CTRL_GPIO_66
R/W-1h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2478. Register 308 Field Descriptions
Bit Field Type Reset Description
2-0
PULL_CTRL_GPIO
_66
R/W 1h
Bit 0 indicates Pull up enable.
Bit <1> Indicates Pull value.
Bit <2> is unused.
2.16.200 Register 309h (offset = 309h) [reset = 2h]
Figure 2-2463. Register 309h
7 6 5 4 3 2 1 0
IBUF_ST_GPIO_66
R/W-2h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2479. Register 309 Field Descriptions
Bit Field Type Reset Description
1-0
IBUF_ST_GPIO_6
6
R/W 2h Input buffer signal strength
2.16.201 Register 30Ah (offset = 30Ah) [reset = 0h]
Figure 2-2464. Register 30Ah
7 6 5 4 3 2 1 0
ODRIV_DS_GPIO_66
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2480. Register 30A Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
66
R/W 0h output buffer drive strength.