Texas Instruments AFE79 Series - 2.13.430 Register 5 D1 h (offset = 5 D1 h) [reset = 0 h]; 2.13.431 Register 5 D4 h (offset = 5 D4 h) [reset = 0 h]; 2.13.432 Register 5 D5 h (offset = 5 D5 h) [reset = 0 h]

RX Top Register Map www.ti.com
838
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
2.13.430 Register 5D1h (offset = 5D1h) [reset = 0h]
Figure 2-1842. Register 5D1h
7 6 5 4 3 2 1 0
RX_AGC_AVG_PWR_DET_SEEN[15:8]
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1855. Register 5D1 Field Descriptions
Bit Field Type Reset Description
7-0
RX_AGC_AVG_P
WR_DET_SEEN[1
5:8]
R 0h
Indicates average power seen by the power detector. Based
on pwr_det_read_sel corresponding power detector is
selected. Update pulse needs to be provided for reading this.
Power read will be equal to 10 * log (value read/65535)
2.13.431 Register 5D4h (offset = 5D4h) [reset = 0h]
Figure 2-1843. Register 5D4h
7 6 5 4 3 2 1 0
RX_AGC_DIG_DET_NUM_HITS_SEEN[7:0]
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1856. Register 5D4 Field Descriptions
Bit Field Type Reset Description
7-0
RX_AGC_DIG_DE
T_NUM_HITS_SE
EN[7:0]
R 0h
Indicates Number of Hits observed. Based on
dig_det_read_sel the corresponding digital peak detector
status is read. This will get updated only when update pulse is
given.. Running accum mode should not be used when
interpreting this.
2.13.432 Register 5D5h (offset = 5D5h) [reset = 0h]
Figure 2-1844. Register 5D5h
7 6 5 4 3 2 1 0
RX_AGC_DIG_DET_NUM_HITS_SEEN[15:8]
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1857. Register 5D5 Field Descriptions
Bit Field Type Reset Description
7-0
RX_AGC_DIG_DE
T_NUM_HITS_SE
EN[15:8]
R 0h
Indicates Number of Hits observed. Based on
dig_det_read_sel the corresponding digital peak detector
status is read. This will get updated only when update pulse is
given.. Running accum mode should not be used when
interpreting this.