Texas Instruments AFE79 Series - 2.16.326 Register 4 ABh (offset = 4 ABh) [reset = 0 h]; 2.16.327 Register 4 ACh (offset = 4 ACh) [reset = 1 h]; 2.16.328 Register 4 AFh (offset = 4 AFh) [reset = 0 h]

www.ti.com IO Wrap Register Map
1101
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
2.16.326 Register 4ABh (offset = 4ABh) [reset = 0h]
Figure 2-2589. Register 4ABh
7 6 5 4 3 2 1 0
ACTIV_BIR_DIR_CTRL_GPIO_42 reserved
R/W-0h R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2605. Register 4AB Field Descriptions
Bit Field Type Reset Description
3-1
ACTIV_BIR_DIR_C
TRL_GPIO_42
R/W 0h
Control to indicate whether the GPIO_42 needs dynamic
ouptu t enabling.
0 to 3 --> Static direction
4 --> Use the IO for 3 pin SPI B2 SDIO.
5 --> Use the IO for 4 pin SPI B2 SDO
6 --> Use the IO for 3 pin SPI B1 SDIO.
7 --> use the IO for 4 pin SPI B1 SDO.
0-0 reserved R/W 0h
2.16.327 Register 4ACh (offset = 4ACh) [reset = 1h]
Figure 2-2590. Register 4ACh
7 6 5 4 3 2 1 0
reserved reserved BUF_DIR_CTRL_GPIO_43
R/W-0h R/W-0h R/W-1h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2606. Register 4AC Field Descriptions
Bit Field Type Reset Description
7-5 reserved R/W 0h
4-2 reserved R/W 0h
1-0
BUF_DIR_CTRL_G
PIO_43
R/W 1h
Controls the direction of GPIO
0 both input and output are not selected.. can be used for
analog
1 input mode
2 output mode
3 shouldnt be used
2.16.328 Register 4AFh (offset = 4AFh) [reset = 0h]
Figure 2-2591. Register 4AFh
7 6 5 4 3 2 1 0
ACTIV_BIR_DIR_CTRL_GPIO_43 reserved
R/W-0h R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset