configure stpd hellotime
ExtremeWare Software 7.3.0 Command Reference Guide 1009
configure stpd hellotime
configure stpd <spanning tree name> hellotime <seconds>
Description
Specifies the time delay (in seconds) between the transmission of Bridge Protocol Data Units (BPDUs)
from this STPD when it is the Root Bridge.
Syntax Description
Default
2 seconds.
Usage Guidelines
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
The range for the
<seconds>
parameter is 1 through 10 seconds.
Example
The following command sets the time delay from STPD1 to 10 seconds:
configure stpd stpd1 hellotime 10
History
This command was first available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
spanning tree name Specifies an STPD name on the switch.
seconds Specifies the hello time in seconds.
To Next Page
Loading...
Need help?
General
