Extreme Networks ExtremeWare - Show Wireless Ports Interface Ap-Scan Results

show wireless ports interface ap-scan results
ExtremeWare Software 7.3.0 Command Reference Guide 2075
show wireless ports interface ap-scan results
show wireless ports [<portlist> | all] interface [1 | 2] results {detail}
Description
Displays information about the results of an access point (AP) scan from the port perspective.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to see the results of an AP scan. Use the optional keyword, detail , to see all of the
fields in
Table 33.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
detail (Optional) Specifies to display the information in detailed format.
Table 34: AP Scan Results (Alphabetized)
Data Value Description
APMAC MAC address of the discovered AP
Capability Capability field from a received information packet (in detail
output only)
Channel The channel on which this AP was discovered
ESS Name String ESS ID I.E.
Last Update Time value at which this entry was updated
Min/Max/Avg RSS Received Signal Strength statistics
Network Type Ad-hoc or BSSID network (in detail output only)
Number of beacons Count of beacon packets seen from this AP (in detail output only)
Number of probe resp Count of PROBE RESP packets sent from the AP (in detail
output only)
Supported Rate Set List of supported rates
WEP required/WEP authentication supported WEP information from beacon and probe packets
WPA WPA information, including authentication and supported
encryption algorithms