Extreme Networks ExtremeWare - Configure Debug-Trace Flowstats

configure debug-trace flowstats
ExtremeWare Software 7.3.0 Command Reference Guide 2153
configure debug-trace flowstats
configure debug-trace flowstats <debug level>
Description
This command records debug information to the system log.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The debug level range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for flowstats errors to 3:
configure debug-trace flowstats 3
History
This command was first available in ExtremeWare 6.2.2.
Platform Availability
This command is available on all platforms.
debug level Specifies a debug level:
0 — Records error messages, such as cannot open a socket, cannot bind a socket,
or cannot add or remove a flow from health-check.
1 — No additional information recorded.
2 — No additional information recorded.
3 — No additional information recorded.
4 — No additional information recorded.
5 — Displays informational messages, such as adding or deleting a flow collector.
6 — No additional information recorded.
7 — Displays debug messages such as enabling and disabling ping-check, IP
address of flow collector, and port, flow collector, and flow group information for
each packet, as well as a packet dump.