1686 ExtremeWare Software 7.3.0 Command Reference Guide
PoS Commands
show ppp
show ppp {<portlist>} {detail}
Description
Displays status information for PPP ports.
Syntax Description
Default
By default, the command shows summarized status for the PPP port(s).
Usage Guidelines
The
portlist
parameter can be used to specify the port(s) for which status is to be shown.
Alternatively, you can enter
show ppp
with no parameters to obtain status for all PPP ports. More
detailed status information can be obtained for the PPP port(s) by specifying the detail parameter.
Summary status includes the following information for each PPP port:
• Values of all PPP configuration parameters
• Physical link status
— operational
— down
— LCP state
— IPCP/BCP state
— EDPCP state
— MPLSCP state
— OSINLCP state
— link packet and octet counters
Detailed status includes the information reported in the summary status along with the following
additional status and management counters:
• Detailed link status
— PPP link phase
• Detailed LCP status
— LCP options negotiated (local and remote)
— LCP packet counters
— number of link-down events due to PPP maintenance
• Detailed authentication status
portlist Specifies the port number(s).
detail Displayed more detailed status information for the PPP ports.
To Next Page
Loading...