262 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Configuring Slots and Ports on a Switch
disable sharing
disable sharing [<port>]
Description
Disables a load-sharing group of ports.
Syntax Description
Default
Disabled.
Usage Guidelines
This command increases bandwidth tracking and resiliency.
On a modular switch,
<port>
is specified as <
slot>:<port number>
. On a stand-alone switch,
<port>
is the port configured as the load-sharing master port. For a detailed explanation of port specification,
see
“Modular Switch Numerical Ranges” or “Stand-alone Switch Numerical Ranges” in Chapter 1.
When sharing is disabled, the master port retains all configuration including VLAN membership.
Configuration for all other member ports is reset to default values. Member ports are removed from all
VLANs to prevent loops.
Example
The following command disables sharing on master logical port 9, which contains ports 9-12 on a
stand-alone switch:
disable sharing 9
The following command disables sharing on master logical port 9 in slot 3, which contains ports 9
through 12 on a modular switch:
disable sharing 3:9
History
This command was first available in ExtremeWare 2.0.
This command was modified in ExtremeWare 4.0 to support modular switches.
Platform Availability
This command is available on all platforms.
port Specifies the master port of a load-sharing group. On a modular switch, is a
combination of the slot and port number, in the format <slot>:<port>.
To Next Page
Loading...