Extreme Networks ExtremeWare User Manual

configure transceiver-test period
ExtremeWare Software 7.3.0 Command Reference Guide 663
configure transceiver-test period
configure transceiver-test period <period <1-60>>
Description
Configures how often the switch runs the transceiver test.
Syntax Description
Default
12 seconds.
Usage Guidelines
Use this feature when the switch can be brought off-line.
Configuring the transceiver test period to 11 seconds or less can affect system performance; therefore,
Extreme Networks does not recommend changing the default transceiver test period. The default is
adequate for most networks.
Example
The following command configures the transceiver test to run every 15 seconds:
configure transceiver-test period 15
History
This command was first available in ExtremeWare 6.2.2b108.
This command was not supported in ExtremeWare 7.0.
This command is supported in ExtremeWare 7.1.0.
Platform Availability
This command is available on modular switches only.
period <1-60> Specifies, in seconds, how often the transceiver test runs. The range is 1 to
60.

Extreme Networks ExtremeWare Specifications

General

Brand	Extreme Networks
Model	ExtremeWare
Category	Software
Language	English