configure pim timer vlan
ExtremeWare Software 7.3.0 Command Reference Guide 1517
configure pim timer vlan
configure pim timer <hello interval> <join prune interval> vlan [<vlan
name>]
Description
Configures the interface-specific PIM timers.
Syntax Description
Default
• hello interval—30 seconds.
• join prune interval—60 seconds.
Usage Guidelines
None.
Example
The following command configures the global PIM timers on the VLAN accounting:
configure pim timer 150 300 vlan accounting
History
This command was first available in ExtremeWare 4.0.
Platform Availability
This command is available on all platforms.
hello interval Specifies the amount of time before a hello message is sent out by the PIM
router. The range is 1 to 65,519 seconds.
join prune interval Specifies the join/prune interval. The range is 1 to 65,519 seconds.
vlan name Specifies a VLAN name.
To Next Page
Loading...