enable rip export static cost
ExtremeWare Software 7.3.0 Command Reference Guide 1371
enable rip export static cost
enable rip export static cost <number> {tag <number>}
Description
Enables the redistribution of static routes with cost preference.
Syntax Description
Default
Disabled.
Usage Guidelines
Static routes are manually entered into the routing table. Static routes are used to reach networks not
advertised by routers. You can configure 64 static unicast routes. Static routes can also be used for
security reasons, enabling you to control which routes you want advertised by the router. You can
decide if you want all static routes to be advertised. Static routes are never aged out of the routing table.
A static route must be associated with a valid IP subnet. An IP subnet is associated with a single VLAN
by its IP address and subnet mask. If the VLAN is subsequently deleted, the static route entries using
that subnet must be deleted manually.
Example
The following command enables the redistribution of static routes with cost preference of 5:
enable rip export static cost 5
History
This command was first available in ExtremeWare 7.3.0.
Platform Availability
This command is available on all platforms.
cost <number> Specifies a cost metric.
tag <number> Specifies a tag number.
To Next Page
Loading...
Need help?
General
