1722 ExtremeWare Software 7.3.0 Command Reference Guide
T1, E1, and T3 WAN Commands
create multilink
create multilink <groupname>
Description
Creates an MLPPP multilink group
.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to create a multilink group. Like the
create vlan
command, the
multilink
keyword must be used when creating the multilink group. Once the group is created, ExtremeWare
recognizes the group name as a multilink group, so the
multilink
keyword is not needed in other
commands that manipulate multilink groups.
Example
The following command creates the multilink group ml_remote:
create multilink ml_remote
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
groupname Specifies the multilink group name.
To Next Page
Loading...