1030 ExtremeWare Software 7.3.0 Command Reference Guide
STP Commands
disable stpd rapid-root-failover
disable stpd <spanning tree name> rapid-root-failover
Description
Disables rapid root failover for STP recovery times.
Syntax Description
Default
Disabled.
Usage Guidelines
To view the status of rapid root failover on the switch, use the
show stpd
command. The
show stpd
command displays information about the STPD configuration on the switch including the
enable/disable state for rapid root failover.
Example
The following command disables rapid root fail over on STPD Backbone_st:
disable stpd backbone_st rapid-root-failover
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
spanning tree name Specifies an STPD name on the switch.
To Next Page
Loading...
Need help?
General
