1932 ExtremeWare Software 7.3.0 Command Reference Guide
Power Over Ethernet Commands
unconfig inline-power backup-source slot
unconfig inline-power backup-source slot <slot_number>
Description
Resets the backup power source to its default for the specified slot. Will not take effect until the power
is cycled on the slot.
Syntax Description
Default
Internal.
Usage Guidelines
This command resets the backup power source configured with the following command:
config inline-power backup-source [internal | none] slot <slot_number>
Resetting the backup power source to its default for the specified slot will not take effect until the
power is cycled on the slot.
Example
The following command resets the backup power source to its default for slot 1:
unconfig inline-power backup-source slot 1
History
This command was first available in ExtremeWare 7.2.
Platform Availability
This command is available on Alpine series I/O modules only.
slot_number Specifies the slot for which the backup power source will be reset to its
default.
To Next Page
Loading...