90 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Accessing the Switch
enable clipaging
enable clipaging
Description
Enables the pause mechanism and does not allow the display to print continuously to the screen.
Syntax Description
This command has no arguments or variables.
Default
Enabled.
Usage Guidelines
The command line interface (CLI) is designed for use in a VT100 environment. Most
show
command
output will pause when the display reaches the end of a page.
To view the status of CLI paging on the switch, use the
show management
command. The
show
management
command displays information about the switch including the enable/disable state for CLI
paging.
If CLI paging is enabled and you use the
show tech-support
command to diagnose system technical
problems, the CLI paging feature is disabled.
Example
The following command enables clipaging and does not allow the display to print continuously to the
screen:
enable clipaging
History
This command was first available in ExtremeWare 6.0.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...
Need help?
General
