Extreme Networks ExtremeWare - Abort Diagnostics Cable

1858 ExtremeWare Software 7.3.0 Command Reference Guide
High Density Gigabit Ethernet Commands
abort diagnostics cable
abort diagnostics cable
Description
Discontinues the running of the Cable Diagnostics Module (CDM) to obtain cable diagnostics values for
selected physical ports of the system.
Syntax Description
This command has no syntax or values.
Default
None.
Usage Guidelines
This command aborts the running of cable diagnostics for selected physical ports of the system. To
enable auto-diagnostics collection for selected ports, use the
enable diagnostics cable command.
To disable auto-diagnostics collection for selected ports, use the
disable diagnostics cable
command. To set the starting time for auto-diagnostics collection for selected ports, use the
configure
diagnostics cable
command. To manually run cable diagnostics, use the run diagnostics cable
command.
To view cable diagnostics data, use the show diagnostics cable command.
Example
The following command disables automatic running of cable diagnostics for all ports.
disable diagnostics cable port all
History
This command was first available in ExtremeWare 7.3.0.
Platform Availability
This command is available on
“3”
series I/O modules only.