1010 ExtremeWare Software 7.3.0 Command Reference Guide
STP Commands
configure stpd maxage
configure stpd <spanning tree name> maxage <seconds>
Description
Specifies the maximum age of a BPDU in the specified STPD.
Syntax Description
Default
20 seconds.
Usage Guidelines
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
The range for the
<seconds>
parameter is 6 through 40 seconds.
Note that the time must be greater than, or equal to 2 * (Hello Time + 1) and less than, or equal to 2 *
(Forward Delay –1).
Example
The following command sets the maximum age of STPD1 to 30 seconds:
configure stpd stpd1 maxage 30
History
This command was first available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
spanning tree name Specifies an STPD name on the switch.
seconds Specifies the maxage time in seconds.
To Next Page
Loading...
Need help?
General
