1354 ExtremeWare Software 7.3.0 Command Reference Guide
IGP Commands
enable isis overload
enable isis [level-2 | area <isis area identifier>] overload {at-startup}
{<seconds(1-86400)>}
Description
Enables the setting of the overload bit in the LSP originated by the system in the level 2 subdomain or
level 1 area.
Syntax Description
Default
The default setting is disabled.
Usage Guidelines
The
at-startup
option sets the overload bit at system startup time.
The <
seconds(1-186400)>
parameter sets the duration of the overload bit. If the duration is not
specified, the bit is set until it is disabled. The range is 1 to 186,400 seconds.
Example
The following command enables IS-IS overload for the level 1 area a1 with a duration of 100 seconds:
enable isis area a1 overload 100
History
This command was first available in ExtremeWare v6.1.8 IS-IS tech release and subsequently
incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
level-2 Specifies the level 2 subdomain.
isis area identifier Specifies a level 1 area.
at-startup Specifies that setting the overload bit is enabled at startup.
seconds(1-86400) Specifies the duration of the overload.
To Next Page
Loading...