Extreme Networks ExtremeWare - Configure Ospf Add Vlan Area Link-Type

configure ospf add vlan area link-type
ExtremeWare Software 7.3.0 Command Reference Guide 1291
configure ospf add vlan area link-type
configure ospf add vlan [<vlan name> | all] area <area identifier>
link-type [auto | broadcast | point-to-point] {passive}
Description
Configures the OSPF link type.
Syntax Description
Default
Auto.
Usage Guidelines
The passive parameter indicates that the router only synchronizes and listens, and does not originate or
send any new information on the interface.
Example
The following command configures the OSPF link type as automatic on a VLAN named accounting:
configure ospf add vlan accounting area 0.0.0.1 link-type auto
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
vlan name Specifies a VLAN name.
all Specifies all VLANs.
area identifier Specifies the area to which the VLAN is assigned.
auto Specifies to automatically determine the OSPF link type based on the
interface type.
broadcast Specifies a broadcast link, such as Ethernet. Routers must elect a DR and a
BDR during synchronization.
point-to-point Specifies a point-to-point link type, such as PPP.
passive Specifies to stop sending and receiving packets on this interface.