configure wireless country-code
ExtremeWare Software 7.3.0 Command Reference Guide 2003
configure wireless country-code
configure wireless country-code <code>
Description
Configures the country identifier for the switch.
Syntax Description
Default
Extreme_default.
Usage Guidelines
When the Alpine 3800 is set to factory defaults, you must configure the correct country code using the
country code properties listed in the following table. The country code feature allows you to configure
the approved 802.11a or 802.11b/g “channels” applicable to each of the supported countries.
Extreme Networks ships the Alpine 3800 to be programmed with Extreme Network's special
extreme_default
country code, which brings up only the B/G radio in channel 6, and turns off the A
radio. When an Altitude 300 wireless port is connected and the Alpine 3800 is unable to determine the
country for which the Altitude is programmed, then the
extreme_default
country code is used. You
must program the country code on the Alpine 3800 to enable the remaining channels for the desired
country.
The Altitude 300 wireless port is shipped with a pre-programmed code for the following countries:
• North America (United States, Canada, Hong Kong)
• Japan
• Taiwan
• European Union and the Rest of the World.
If you do not program the country code in the Alpine 3800, then the switch inherits the country code of
the first Altitude 300 wireless port that connects to it, if the Altitude is not programmed for the
'European Union and the Rest of World.
If there is a mismatch between the country codes between the Altitude 300 wireless port and the code
programmed on the Alpine 3800, the Altitude 300 wireless port is not allowed to come up.
code Sets the country identifier for the switch.
Australia Austria Belgium Canada China Denmark
extreme_default Finland France Germany Greece Hong_Kong
Iceland Ireland Italy Japan Korea_Republic Liechtenstein
Luxembourg Mexico Netherlands Norway Portugal Spain
Sweden Switzerland Taiwan Thailand UK USA
To Next Page
Loading...