Extreme Networks ExtremeWare - Configure Wireless Ports Interface Power-Level

2030 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
configure wireless ports interface power-level
configure wireless ports <portlist> interface [1 | 2] power-level <level>
Description
Configures the power-level for the specified interface.
Syntax Description
Default
Full.
Usage Guidelines
Each wireless port on the Alpine 3800 contains two interfaces. Interface 1 supports 802.11a, and interface
2 supports 802.11b/g radio signals. The
configure wireless port interface power-level
command allows you to configure one of the two individual interfaces (1|2) on a port or ports. If there
is radio interference from other devices, then you can adjust the power level to an appropriate level
below full power.
Example
The following command configures the power level to half-power for interface 1 on ports 5 to 16:
configure wireless port 5-16 interface 1 power-level half
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
interface Specifies an interface: 1 or 2.
level Specifies the power level for the interface. Valid values are:
• Full
• Half
• Quarter
• One-eighth
• Min (minimum)