Extreme Networks ExtremeWare - Enable Bgp Peer-Group

enable bgp peer-group
ExtremeWare Software 7.3.0 Command Reference Guide 1471
enable bgp peer-group
enable bgp peer-group <peer group> {soft-in-reset}
{remove-private-AS-numbers}
Description
Enables a peer group and all the neighbors of a peer group.
Syntax Description
Default
Disabled.
Usage Guidelines
You can use BGP peer groups to group together up to 200 BGP neighbors. All neighbors within the peer
group inherit the parameters of the BGP peer group. The following mandatory parameters are shared
by all neighbors in a peer group:
• remote AS
• source-interface
• out-nlri-filter
• out-aspath-filter
• out-route-map
• send-community
• next-hop-self
Example
The following command enables the BGP peer group outer and all its neighbors:
enable bgp peer-group outer
History
This command was available in ExtremeWare 6.1.5.
Platform Availability
This command is available on all platforms.
peer group Specifies a peer group.
soft-in-reset Specifies the soft recognition feature.
remove-private-AS-numbers Specifies to remove private AS numbers.