1904 ExtremeWare Software 7.3.0 Command Reference Guide
Power Over Ethernet Commands
config inline-power detection
config inline-power detection [auto | discovery-test-only] ports <portlist>
Description
Sets the power detection mechanism on the specified ports.
Syntax Description
Default
Auto.
Usage Guidelines
This command controls the power detection mechanism on the specified ports. Test mode forces power
discovery operations; however, power is not supplied to detected PDs.
Example
The following command forces automatic power discovery operations and specifies that power will be
supplied to detected PDs for ports 4 – 6 on slot 3:
config inline-power detection auto ports 3:4-3:6
History
This command was first available in ExtremeWare 7.2.
Platform Availability
This command is available on Alpine series I/O modules only.
auto Forces automatic power discovery operations and specifies that power will be
supplied to detected power devices (PDs) for the specified ports.
discovery-test-only Forces power discovery operations and specifies that power will not be
supplied to detected PDs for the specified ports.
portlist Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
To Next Page
Loading...