Extreme Networks ExtremeWare - Configure Debug Elsm-System

configure debug elsm-system
ExtremeWare Software 7.3.0 Command Reference Guide 1051
configure debug elsm-system
configure debug elsm-system <level>
Description
Configures Extreme Link Status Monitoring (ELSM) debug tracing for the entire system.
Syntax Description
Default
None.
Usage Guidelines
To configure ELSM debug tracing for the entire system, use the following command:
configure debug elsm-system <level>
The levels provide the following information:
• Level 1 is information.
• Level 2 is trace, and is used to trace the path of code execution.
• Levels 3 and above are not used.
To disable debug tracing, set the level to 0.
To configure debug tracing for ELSM ports, use the following command:
configure debug elsm-port <level> <port number>
Example
The following command configures ELSM debug tracing of code execution (Level 2) for the entire
system:
configure debug elsm-system 2
History
This command was first available in ExtremeWare 6.2.2b134.
level Specifies the level of debug tracing:
• 0 - Level 0 disables debug tracing.
• 1 - Level 1 is information.
• 2 - Level 2 is trace, and is used to trace the path of code execution.
Levels 3 and above are not used. To disable debug tracing, set the level to 0.