1306 ExtremeWare Software 7.3.0 Command Reference Guide
IGP Commands
configure ospf lsa-batch-interval
configure ospf lsa-batch-interval <seconds>
Description
Configures the OSPF LSA batching interval.
Syntax Description
Default
The default setting is 30 seconds.
Usage Guidelines
The range is between 0 (disabled) and 600 seconds, using multiples of 5 seconds. The LSAs added to the
LSDB during the interval are batched together for refresh or timeout.
Example
The following command configures the OSPF LSA batch interval to a value of 100 seconds:
configure ospf lsa-batch-interval 100
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
seconds Specifies a time in seconds.
To Next Page
Loading...