Extreme Networks ExtremeWare - Configure Wireless Ports Interface Client-Scan Added-Trap

configure wireless ports interface client-scan added-trap
ExtremeWare Software 7.3.0 Command Reference Guide 2025
configure wireless ports interface client-scan added-trap
configure wireless ports [<portlist> | all] interface [1 | 2] client-scan
addeded-trap [on |off]
Description
Enables or disables traps from the client-scan feature when a new client is detected.
Syntax Description
Default
Off.
Usage Guidelines
Enabling traps can saturate management stations if an area is heavily populated.
Example
The following command enables traps for port 1:5 and interface 2:
configure wireless port 1:5 interface 2 client-scan added-trap on
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
on Enables traps when a new client is detected.
off Disables traps when a new client is detected.