2082 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
show wireless ports interface client-history diagnostics
show wireless ports [<portlist> | all] interface [1 | 2] client-history
diagnostics <mac_address>
Description
Displays counters and errors the information collected on a per-client basis.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to display diagnostic counters and error information contained in the
extremeWirelessClientDiagTable.
Example
The following example displays client-history diagnostics information for port 1:25 and interface 1
based on the MAC address of the client:
show wireless ports 1:25 interface 1 client-history diagnostics 00:0D:54:98:AC:35
The output of the command is similar to:
Interface : 1:25:1
AP Mac Address : 00:0D:54:98:AC:35
State Watermark : FORWARDING
Events In Detected
Enters : 1
Errors : 0
AUTH REQ : 0
Other : 1
MGMT Action : 0
Time Outs : 0
Events In Authenticated
Enters : 1
Errors : 0
ASSOC REQ : 1
Other : 1
MGMT Action : 0
Time Outs : 0
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
mac_address Specifies the MAC address of the wireless client.
To Next Page
Loading...