1420 ExtremeWare Software 7.3.0 Command Reference Guide
BGP Commands
configure bgp neighbor route-map-filter
configure bgp neighbor [<ip address> | all] route-map-filter [in | out]
[none | <route map>]
Description
Configures a route map filter for a neighbor.
Syntax Description
Default
N/A.
Usage Guidelines
The route map filter can be installed on the input or output side of the router. The route map is used to
modify or filter the NLRI information and the path attributes associated with it when exchanging
updates with the neighbor.
Example
The following command configures the route-map-filter filter for a neighbor based on the access profile
nosales:
configure bgp neighbor 192.168.1.22 route-map-filter in nosales
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
ip address Specifies an IP address.
all Specifies all neighbors.
in Specifies to install the filter on the input side.
out Specifies to install the filter on the output side.
none Specifies to remove the filter.
route map Specifies a route map.
To Next Page
Loading...