configure flowstats source ipaddress
ExtremeWare Software 7.3.0 Command Reference Guide 1649
configure flowstats source ipaddress
configure flowstats source ipaddress <ip address>
Description
Configures the IP address that is to be used as the source IP address for NetFlow datagrams to be
exported.
Syntax Description
Default
Normal.
Usage Guidelines
No NetFlow datagrams will be exported until the source
ip address
is configured. Flow-collector
devices may use the source IP address of received NetFlow datagrams to identify the switch that sent
the information. It is recommended that the configured
ip address
be associated with a VLAN that
has loopback mode enabled.
Example
The following command example specifies that the IP address
192.168.100.1
is to be used as the
source IP address for exported NetFlow datagrams:
configure flowstats source ipaddress 192.168.100.1
History
This command was first available in an ExtremeWare IP Technology Services Release based on v6.1.5b20
for the PoS module only.
Platform Availability
This command is available on the BlackDiamond switch only.
ip address Specifies the source IP address to be used as the source for NetFlow
datagrams to be exported.
To Next Page
Loading...