configure debug-trace debug-link
ExtremeWare Software 7.3.0 Command Reference Guide 2139
configure debug-trace debug-link
configure debug-trace debug-link <debug level>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The
debug level
range is 0 to 5. Level 0 disables the debug-trace for link detection, and level 1 enables
debug-trace for link detection.
For levels 2 through 5, no additional information recorded.
Example
The following command enables debug-trace for link detection:
configure debug-trace debug-link 1
The following command disables debug-trace for link detection:
configure debug-trace debug-link 0
History
This command was first available in ExtremeWare 6.2.2b108.
Platform Availability
This command is available on all platforms.
debug level Specifies a debug level:
0 — Disables debug tracing for debug link and stops recording information to the syslog.
1 — Enables debug tracing for debug link and records information to the syslog.
2 — No additional information recorded.
3 — No additional information recorded.
4 — No additional information recorded.
5 — No additional information recorded.
To Next Page
Loading...