Extreme Networks ExtremeWare - Configure Snmpv3 Add Filter-Profile

configure snmpv3 add filter-profile
ExtremeWare Software 7.3.0 Command Reference Guide 129
configure snmpv3 add filter-profile
configure snmpv3 add filter-profile {hex} <profile name> param {hex} <param
name> {volatile}
Description
Associate a filter profile with a parameter name.
Syntax Description
Default
The default storage type is non-volatile.
Usage Guidelines
Use this command to add an entry to the snmpNotifyFilterProfileTable. This table associates a filter
profile with a parameter name. The parameter name is associated with target addresses, and the filter
profile is associated with a series of filters, so, in effect, you are associating a series of filters with a
target address.
Example
Use the following command to associate the filter profile prof1 with the parameter name P1:
configure snmpv3 add filter-profile prof1 param P1
History
This command was first available in ExtremeWare 7.1.0.
Platform Availability
This command is available on all platforms.
hex Specifies that the value to follow is to be supplied as a colon separated string
of hex octets.
profile name Specifies the filter profile name.
param name Specifies a parameter name to associate with the filter profile.
volatile Specifies volatile storage.