show wireless ports interface clients
ExtremeWare Software 7.3.0 Command Reference Guide 945
show wireless ports interface clients
show wireless ports [<portlist> | all] interface [1 | 2] clients {detail}
Description
Displays wireless client state.
Syntax Description
Default
N/A.
Usage Guidelines
Client current state information is available for all clients that have sent an authentication message to
the Altitude 300. Information in the client state table is timed out if no packets are received from the
client by the configurable period of time set by the administrator.
Examples
The following example shows the clients on port 1:8 on interface 1:
show wireless ports 1:8 interface 1 clients
It produces output similar to the following:
Wireless Client Statistics
MAC ADDR Port STATE ENC AUTH TIME RSS
================================================================================
00:09:5B:A1:1F:8F 1:1 FORWARD AES PSK 4:36:20 200
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
detail (Optional) Specifies to display the information in detailed format.
To Next Page
Loading...
Need help?
General
