288 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Configuring Slots and Ports on a Switch
show ports configuration
show ports {mgmt | <portlist>} configuration
Description
Displays port configuration statistics.
Syntax Description
Default
N/A.
Usage Guidelines
On a modular switch,
<portlist>
can be a list of slots and ports. On a stand-alone switch,
<portlist>
can be one or more port numbers. For a detailed explanation of port specification, see
“Modular Switch
Numerical Ranges” or “Stand-alone Switch Numerical Ranges” in Chapter 1.
If you do not specify a port number or range of ports, configuration statistics are displayed for all ports.
This status information may be useful for your technical support representative if you have a network
problem.
This command displays port configuration, which includes:
• Port state
• Link state
• Link speed
• Duplex mode
• Flow control
• Load sharing information
• Link media information
For version 6.0 and later:
• Auto on/off
Example
The following command displays the port configuration statistics for all ports on a switch:
show ports config
mgmt Specifies the management port. Supported only for switches that provide a
management port.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:*, 2:5, 2:6-2:8.
To Next Page
Loading...