2222 ExtremeWare Software 7.3.0 Command Reference Guide
Troubleshooting Commands
show diagnostics packet-memory slot
show diagnostics packet-memory [slot <slot number>]
Description
Displays the results of the packet memory scan on BlackDiamond 6808 and BlackDiamond 6816 I/O
modules.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to display the results of a packet memory scan. The command output displays the
number of defects identified, and the number that were recoverable. If packet memory defects were
found, it displays information about each defect.
In ExtremeWare 6.2.1, this applies only to the G8Xi, G8Ti, G12SXi, and F48Ti. MSM blades are not
supported in this release. In ExtremeWare 6.2.2, this apples to all “i”series modules and switches.
Example
The following command displays the results of a PM scan for slot 2, where a single defect was found:
show diagnostics packet-memory slot 2
If no defects are found, the output will look similar to the following:
------------------------------------------------------
Packet memory defect info for card 1
------------------------------------------------------
Num of defects = 0, num of recoverable defects = 0
------------------------------------------------------
If defects are found, the output displays the number of defects, and provides information about each
identified defect.
------------------------------------------------------
Packet memory defect info for card 2
------------------------------------------------------
Num of defects = 1, num of recoverable defects = 1
Defect information:
Defect entry 1
slot number Specifies the slot number of an I/O module.
To Next Page
Loading...