202 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Managing the Switch
show snmpv3 filter
show snmpv3 filter {{hex} <profile name> {{subtree} <object identifier>}
Description
Display the filters that belong a filter profile.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to display entries from the snmpNotifyFilterTable. If you specify a profile name and
subtree, you will display only the entries with that profile name and subtree. If you specify only the
profile name, you will display all entries for that profile name. If you do not specify a profile name,
then all the entries are displayed.
Example
Use the following command to display the part of filter profile prof1 that includes the MIB subtree
1.3.6.1.4.1:
show snmpv3 filter prof1 subtree 1.3.6.1.4.1
History
This command was first available in ExtremeWare 7.1.0.
Platform Availability
This command is available on all platforms.
hex Specifies that the value to follow is to be supplied as a colon separated string
of hex octets.
profile name Specifies the filter profile to display.
object identifier Specifies a MIB subtree.
To Next Page
Loading...
Need help?
General
