428 ExtremeWare Software 7.3.0 Command Reference Guide
NAT Commands
configure nat syn-timeout
configure nat syn-timeout <seconds>
Description
Configures the timeout for an entry with an unacknowledged TCP SYN state.
Syntax Description
Default
Default timeout is 60 seconds.
Usage Guidelines
Setting the timeout to zero specifies that session table entries should not be timed-out. This is not
normally recommended as NAT resources will get used up.
Example
The following command configures the timeout for a session with an unacknowledged SYN packet to
120 seconds:
configure nat syn-timeout 120
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
seconds Specifies the number of seconds to wait before the session table entry times
out.
To Next Page
Loading...