Extreme Networks ExtremeWare - Configure Debug-Trace Transceiver-Test

2194 ExtremeWare Software 7.3.0 Command Reference Guide
Troubleshooting Commands
configure debug-trace transceiver-test
configure debug-trace transceiver-test <debug level>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The debug level range is 0 to 5. Level 0 disables the debug-trace for the transceiver testing, and level 1
enables debug-trace for the transceiver testing.
For levels 2 through 5, debug-trace for transceiver testing is enabled, but no additional information is
recorded.
Example
The following command enables debug-trace for transceiver testing:
configure debug-trace transceiver-test 1
Following is sample log output at this level:
07/09/2003 15:09:14.02 <Info:TRXDIAG> trxdiag: EXT MAC test on slot 2 returns pass
07/09/2003 15:09:14.02 <Info:TRXDIAG> trxdiag: EXT MAC test on slot 4 returns pass
07/09/2003 15:09:14.02 <Info:TRXDIAG> trxdiag: CPU SRAM test on BPLNE returns pass
07/09/2003 15:09:14.02 <Info:TRXDIAG> trxdiag: CPU FLASH test on BPLNE returns pass
07/09/2003 15:09:14.02 <Info:TRXDIAG> trxdiag: CPU NVRAM test on BPLNE returns pass
07/09/2003 15:09:14.03 <Info:TRXDIAG> trxdiag: TWISTER test on BPLNE returns pass
07/09/2003 15:09:14.03 <Info:TRXDIAG> trxdiag: QUAKE test on BPLNE returns pass
07/09/2003 15:09:15.00 <Info:TRXDIAG> trxdiag: EXT MAC test on slot 1 returns pass
07/09/2003 15:09:15.00 <Info:TRXDIAG> trxdiag: EXT MAC test on slot 2 returns pass
07/09/2003 15:09:15.00 <Info:TRXDIAG> trxdiag: EXT MAC test on slot 4 returns pass
07/09/2003 15:09:15.00 <Info:TRXDIAG> trxdiag: CPU SRAM test on BPLNE returns pass
07/09/2003 15:09:15.00 <Info:TRXDIAG> trxdiag: CPU FLASH test on BPLNE returns pass
07/09/2003 15:09:15.00 <Info:TRXDIAG> trxdiag: CPU NVRAM test on BPLNE returns pass
debug level Specifies a debug level:
0 — Disables debug tracing for the transceiver test and stops recording information to the
syslog.
1 — Enables debug tracing for the transceiver test and records information to the syslog.
2 — No additional information recorded.
3 — No additional information recorded.
4 — No additional information recorded.
5 — No additional information recorded.