618 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Status Monitoring and Statistics
configure log display
configure log display {<severity>}
Description
Configures the real-time log display.
Syntax Description
Default
If not specified, messages of all severities are displayed on the console display.
Usage Guidelines
You must enable the log display before messages are displayed on the log display. Use the
enable log
display
command to enable the log display. This allows you to configure the system to maintain a
running real-time display of log messages on the console.
Options for displaying the real-time log display include:
• severity—Filters the log to display messages with the selected severity or higher (more critical).
Severities include critical, error, warning, info, notice, debug-summary, debug-verbose, and
debug-data.
In ExtremeWare 7.1.0, the ability to control logging to different targets was introduced. The new
command equivalent to
configure log display
is the following:
configure log target console-display severity <severity>
To display the current configuration of the log display, use the following command:
show log configuration target console-display
Example
The following command configures the system log to maintain a running real-time display of log
messages of critical severity:
configure log display critical
History
This command was first available in ExtremeWare 2.0.
The severity levels alert and emergency were deprecated to critical, and the levels debug-summary,
debug-verbose, and debug-data were added in ExtremeWare 7.1.0.
severity Specifies a message severity. Severities include critical, error, warning, notice,
info, debug-summary, debug-verbose, and debug-data.
To Next Page
Loading...
Need help?
General
