2188 ExtremeWare Software 7.3.0 Command Reference Guide
Troubleshooting Commands
configure debug-trace rip-message
configure debug-trace rip-message <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The
debug level
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for RIP message errors to 3:
configure debug-trace rip-message 3
Following is the log output at this level:
<DBUG:RIP > Sending Rsp to 224.0.0.9 at 1012569160.950000
<INFO:SYST> msm-a-console admin: configure debug-trace rip-message 3 vlan all
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
debug level Specifies a debug level:
0 — None.
1 — None.
2 — None.
3 — Records that the switch received a response from w.x.y.z (pier) len 24 at
time.time.
Records that the switch sent a response to 224.0.0.9 at time.time.
4 — Displays a dump of the RIP response.
Displays a dump of the RIP response received.
5 — No additional information recorded.
vlan name Specifies a VLAN name.
To Next Page
Loading...