enable igmp
ExtremeWare Software 7.3.0 Command Reference Guide 1531
enable igmp
enable igmp {vlan <vlan name>}
Description
Enables IGMP on a router interface. If no VLAN is specified, IGMP is enabled on all router interfaces.
Syntax Description
Default
Enabled.
Usage Guidelines
IGMP is a protocol used by an IP host to register its IP multicast group membership with a router.
Periodically, the router queries the multicast group to see if the group is still in use. If the group is still
active, IP hosts respond to the query, and group registration is maintained.
IGMP is enabled by default on the switch. However, the switch can be configured to disable the
generation and processing of IGMP packets. IGMP should be enabled when the switch is configured to
perform IP unicast or IP multicast routing.
Example
The following command enables IGMP on the VLAN accounting:
enable igmp vlan accounting
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
vlan name Specifies a VLAN name.
To Next Page
Loading...
Need help?
General
