1244 ExtremeWare Software 7.3.0 Command Reference Guide
IP Unicast Commands
show iproute
show iproute {priority | vlan <vlan name> | permanent | <ip address>
<netmask> | route-map |origin [direct | static | blackhole | rip | bootp |
icmp | ospf-intra | ospf-inter | ospf-as-external | ospf-extern1 |
ospf-extern2]} {mpls} {sorted}
Description
Displays the contents of the IP routing table or the route origin priority.
Syntax Description
Default
N/A.
Usage Guidelines
Route maps for IP routing can be configured based on the route origin. When routes are added to the IP
routing table from various sources, the route map configured for the origin of the route is applied to the
route. After matching on specified characteristics, the characteristics for the route can be modified using
the route maps. The characteristics that can be matched and modified are dependent on the origin of the
route. Route maps for IP routing can be dynamically changed. In the case of direct and static route
origins, the changes are reflected immediately. In the case of routes that are sourced from other origin,
the changes are reflected within 30 seconds.
The output of the
show iproute
command has been enhanced to include information about MPLS
LSPs associated with the routes. The flags field displayed by this command has been enhanced to
indicate the presence of MPLS next hops. An uppercase
L
indicates the presence of a direct LSP next
hop for the route. A lowercase
l
indicates the presence of an indirect LSP next hope for the route.
An optional
mpls
keyword has been added to the
show iproute
command. When the
mpls
keyword is
specified, the information displayed is modified; some of the information normally displayed is
omitted, and the LSP endpoint and outgoing MPLS label are displayed instead. The LSP endpoint is the
IP address/prefix of the FEC associated with the LSP. The LSP endpoint matches the destination for
direct LSPs and is a 32-bit prefix address of a proxy router for indirect LSPs.
priority Specifies a route priority.
vlan name Specifies a VLAN name.
permanent Specifies permanent routing.
ip address Specifies an IP address.
netmask Specifies a subnet mask.
route-map Specifies display of route maps for direct, static, blackhole, RIP, BOOTP,
ICMP, OSPF-intra, OSPF-inter, OSPF as External, OSPF External 1, and
OPPF External 2 routing.
origin Specifies a display of the route map origin.
mpls Specifies to display MPLS information.
sorted Specifies to sort the information displayed.
To Next Page
Loading...
Need help?
General
