2148 ExtremeWare Software 7.3.0 Command Reference Guide
Troubleshooting Commands
configure debug-trace dvmrp-timer
configure debug-trace dvmrp-timer <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The
debug level
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for DVMRP timer errors to 3:
configure debug-trace dvmrp-timer 3 vlan v49
Following is the log output at this level:
<INFO:SYST> serial admin: configure debug-trace dvmrp-timer 3 v49
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
debug level Specifies a debug level:
0 — Records error messages.
1 — Records warnings.
2 — Records verbose warnings.
3 — Displays a dump of each packet.
4 — No additional information recorded.
5 — No additional information recorded.
vlan name Specifies a VLAN name.
To Next Page
Loading...