Extreme Networks ExtremeWare - Show Netlogin

show netlogin
ExtremeWare Software 7.3.0 Command Reference Guide 929
show netlogin
show netlogin {port <portlist> vlan <vlan name>}
Description
Shows status information for Network Login.
Syntax Description
Default
N/A.
Usage Guidelines
The information reported by this command is the following:
• Whether Network Login is enabled or disabled.
• The base-URL.
• The default redirect page.
• The logout privileges setting.
• The netlogin session-refresh setting and time.
• The MAC and IP address of supplicants
• The type of authentication, 802.1x or HTTP (web-based).
Example
The following command shows the summary Network Login information:
show netlogin
Following is the output from this command:
Netlogin Authentication Mode : web-based ENABLED ; 802.1x ENABLED
------------------------------------------------
Web-based Mode Global Configuration
------------------------------------------------
Base-URL : "network-access.net"
Default-Redirect-Page : "http://www.extremenetworks.com"
Logout-privilege : YES
Netlogin Session-Refresh : DISABLED ; 3 minutes
------------------------------------------------
------------------------------------------------
802.1x Mode Global Configuration
------------------------------------------------
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
vlan name Specifies the name of a VLAN.