show ospf virtual-link
ExtremeWare Software 7.3.0 Command Reference Guide 1385
show ospf virtual-link
show ospf virtual-link {routerid <routerid> <area identifier>}
Description
Displays virtual link information about a particular router or all routers.
Syntax Description
Default
N/A.
Usage Guidelines
area identifier—Transit area used for connecting the two end-points. The transit area cannot have the IP
address 0.0.0.0.
Example
The following command displays virtual link information about a particular router:
show ospf virtual-link routerid 1.2.3.4 10.1.6.1
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
routerid Specifies a router interface number.
area identifier Specifies an OSPF area.
To Next Page
Loading...